Error Messages - Brother NX-200 Operation Manual

Symptom
The feed dogs are lowered.
The stitch is too fine.
The presser foot that is used is not
appropriate for the type of stitch that
you wish to sew.
The fabric does
not feed.
The pressure of the presser foot is
weak.
The thread is tangled, for example,
in the shuttle.
The sewing lamp
does not come on. The sewing lamp is damaged.

Error messages

If the start/stop button is pressed before the sewing machine is correctly set up or if an operation is performed
incorrectly, an error message appears in the stitch indicator. Follow the instructions that appear.
If you press
(Stitch selection key)
message disappears.
Error Message
Probable Cause
or do the operation correctly while the error message is displayed, the
The start/stop button or reverse/reinforcement stitch but-
ton was pressed while the presser foot was raised.
A stitch other than the buttonhole or bar tack stitch was
selected and the start/stop button was pressed while the
buttonhole lever is lowered.
The buttonhole or bar tack stitch was selected and the
start/stop button was pressed while the buttonhole lever
is raised.
The reverse/reinforcement stitch button or needle posi-
tion button was pressed while the bobbin winder shift is
moved to the right.
The start/stop button was pressed while the foot control-
ler was connected.
The motor locked up because the thread is tangled.
Remedy
Slide the drop feed lever to the left.
Lengthen the stitch length.
Attach the presser foot that is appro-
priate for the type of stitch that you
wish to sew.
Turn the presser foot pressure dial to
the right to increase the pressure of
the presser foot.
Remove the tangle thread. If the
thread is tangled in the shuttle, clean
the shuttle.
Contact your retailer or the nearest
authorized service center.
Probable Cause
Reference
page 67, 81
page 46
page 92
page 30
page 96
–
Troubleshooting 101