Changing The Stitch Width - Brother Innov-is 40 Operation Manual

UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

■ Changing the stitch width

Press the "+" or "–" side of the stitch width key to
adjust the stitch width.
a Stitch width key
b Stitch width
c Narrow
d Wide
Memo
● Before sewing buttonholes, check the stitch
length and width by sewing a trial
buttonhole on a scrap piece of fabric.
■ Sewing buttonholes on stretch fabrics
When sewing buttonholes on stretch fabrics, use a
gimp thread.
Hook the gimp thread onto the part of
a
buttonhole foot "A" shown in the illustration
so that it fits into the grooves, and then
loosely tie it.
b Turn on the sewing machine.
Select stitch or
c
60
– +
.
Attach buttonhole foot "A".
d
• For details, refer to "Replacing the presser
foot" (page 31).
e Adjust the stitch width to the thickness of the
gimp thread.
Lower the presser foot lever and the
f
buttonhole lever, and then start sewing.
When sewing is finished, gently pull the gimp
g
thread to remove any slack.
h Use a handsewing needle to pull the gimp
thread to the wrong side of the fabric, and
then tie it.
i With a seam ripper, cut the middle part of the
gimp thread remaining at the top end of the
buttonhole.
Trim off any excess of the gimp thread.
Note
● If gimp thread is not available use a thread
or cord of at least 12 weight.