MSI NF725-C35 Series Manual page 25

adjusted CPu-nB Frequency (MHz)
it shows the adjusted CPu-nB frequency. Read-only.
MeMoRy-Z
Press <enter> to enter the sub-menu.
diMM~2 Memory SPd information
Press <enter> to enter the sub-menu. this sub-menu displays the information
of installed memory.
advance dRaM Configuration
Press <enter> to enter the sub-menu.
dRaM timing Mode
this field has the capacity to automatically detect the dRaM timing when it
sets as [auto].
t/2t Memory timing
When the dRaM timing Mode is set to [Manual], the field is adjustable. this
field controls the command rate. Selecting [t] makes dRaM signal controller
to run at  clock cycle rate. Selecting [2t] makes dRaM signal controller run
at 2 clock cycles rate.
dCt unganged Mode
this feature is used to integrate two 64-bit dCts into a 28-bit interface.
FSB/dRaM Ratio
this item will allow you to adjust the ratio of FSB to memory.
adjusted dRaM Frequency (MHz)
it shows the adjusted memory frequency. Read-only.
adjusted Ht Link Frequency (MHz)
it shows the adjusted Ht link frequency. Read-only.
auto disable PCi/PCi-e Frequency
When set to [enabled], the system will remove (turn off) clocks from empty PCi
and PCi-e slots to minimize the electromagnetic interference (eMi).
dRaM Voltage (V)
this item is used to adjust the voltage of Memory.
MS-765
25