Troubleshooting; Warranty Information - NutriMill Harvest Owner's Manual

TROUBLESHOOTING

Motor will not start.
Motor stalls during operation.
This may be caused from
overheating or improper use.
The Harvest mill has a built-in
thermal cut-off switch that stops
the motor to prevent serious
damage.
Unusual smell or noise
If problem persists, troubleshoot the source:
• Is grain too moist?
• Are millstones or mill chamber clogged?
• Is a foreign object caught between the millstones?
• Was the mill turned on when hopper was filled and millstones were at finest
grind setting?

WARRANTY INFORMATION

L'Chef, LLC warrants the NutriMill Harvest
and workmanship for a period of 5 years. Defective product will be repaired or replaced with
a comparable model at our sole discretion upon receiving the defective product. L'Chef will
not refund purchase price or provide any other remedy. This warranty applies to the original
noncommercial purchaser.
Warranty does not cover damage resulting from accident, misuse, shipping, normal wear,
commercial use, neglect, incidental or consequential damages, or from damage caused by any
foreign objects getting into the mill.
YOU MUST keep a dated sales receipt for warranty service.
To ensure full warranty, return the mill, securely packed, to:
L'CHEF
Attn: Service Dept.
825 N. Industrial Road
St. George, UT 84770
Include a copy of dated sales receipt, name, address information, phone number, email address
and a statement giving specific reason for return.
For your convenience, there is a Request for Warranty Service Form located at
www.lchef.com. Click on the warranty button. For more information call customer service at
1.877.267.2434 or email: service@lchef.com.
Rotate adjusting knob to coarse setting (counterclock-
wise) until motor starts. Then adjust texture knob to
desired setting.
Unplug and allow mill to cool down. Remove hopper,
empty any left over grains or legumes, and remove
upper millstone. Make sure stones and milling chamber
are clean and dry after allowing the motor to cool (30
minutes or more). Try restarting motor with upper stone
and hopper off. If the motor starts, turn off the mill.
Reassemble and begin milling.
Milling heads rubbing too tightly during operation.
Rotate the adjustment knob to a coarser setting.
®
mill to be free of manufacturing defects in materials
English 6