Troubleshooting - Philips Aleor 300 Manual

F Telephone troubleshooting.....
PROBLEMS
- No dialling tone when
pressing .
- icon is blinking.
- When the handset is placed
on the charging unit, no beep
is heard.
- Battery icon remains empty
although the handset has
charged for 24 hours.
- No symbol on the display.
- A phonebook entry has not
been memorised.
- Bad audio quality (crackles,
muted, echo, etc.).
- Caller display does not work. Service not activated.

Troubleshooting

CAUSES
- The base station is not properly
connected to electricity or to the
telephone sockets.
- Too far from the base station
- Battery pack is low (low battery icon
is displayed).
- The handset is not registered.
- The handset is out of range.
- The handset is not placed correctly
on the base station charging unit.
- Charging contacts are dirty.
Handset battery pack is defective.
Battery pack is uncharged.
The phonebook you wish to use is full. Delete some entries to free
- Interference from nearby electrical
appliance.
- Base station installed in a room with
thick walls.
- You are using the handset too far
from the base station.
SOLUTIONS
- Check the connections.(inside
cover).
- Move closer to the base
- Charge battery pack. (inside
cover).
- Register the handset to the base
station. (p 10)
- Move closer to the base station.
- Take the handset off the base
station and put it back again.
- Clean them with a clean and dry
cloth.
Please contact your PHILIPS
dealer in order to purchase new
rechargeable battery pack.
Make sure your product is plugged
in. (inside cover).
Charge battery pack. (inside cover).
memory space.
- Try to plug the base station in
elsewhere.
- Install the base station in a
different room.
- Move closer to the base station.
Check your subscription with your
operator.
11