Parts Description; Charging Time - Makita ADP10 Instruction Manual

Interchangeable adapter
Hide thumbs Also See for ADP10:
Table of Contents

Advertisement

Available languages

Available languages

PARTS DESCRIPTION

► Fig.1
1.
Battery cartridge
2.
Interchangeable adapter
3.
Terminal cover
4.
Charging light
5.
Battery charger

Charging time

The charging time is as following table.
► Fig.2
*A. Voltage
*B. Battery type
*C. Capacity
*D. Number of cells
*E. Charging time (min.)
NOTE: Charging time varies by temperature (10°C
(50°F)–40°C (104°F)) that battery cartridge is
charged at and conditions of the battery cartridge,
such as a battery cartridge which is new or has not
been used for a long period of time.
Charging
CAUTION:
Follow the steps instructed in this
manual. If you insert the battery with the adapter to
the charger mounted on the wall, the battery or the
adapter may come off and fall off.
1.
Plug the battery charger into the proper AC volt-
age source.
2.
Insert the adapter into charger until it stops adjust-
ing to the guide of charger.
3.
Insert the battery cartridge to the adapter.
4.
When the battery cartridge is inserted fully,
charging will begin.
5.
After charging, remove the battery cartridge from
the adapter while sliding the button on the battery
cartridge.
6.
Remove the adapter from the charger while slid-
ing the button on the adapter. Then unplug the
charger.
NOTICE:
This adapter is for charging Makita
battery cartridge. Never use it for other purposes
or for other manufacturer's batteries.
NOTE: The terminal cover of the charger opens as
you insert the adapter and closes as you pull out the
adapter.
The terminal cover of the adapter also opens as you
insert the battery cartridge and closes as you pull out
the battery cartridge.
NOTE: The pattern of the indicator lamps is varies
depending on the charger.
Refer the instruction manual of the charger to check
the status of charging.
4 ENGLISH

Advertisement

Table of Contents
loading

Table of Contents