Dialing Access Codes And Credit Card Numbers - Brother MFC-J6510DW Advanced User's Manual

Chapter 5
Note
• (USA only) If you redial from the Caller ID
history outside your area code, you must
set up your AREA CODE in advance.
(See Setting up your area code (USA
only) on page 29.)
• You can print the Caller ID List.
(See How to print a report on page 38.)
Dialing access codes and
credit card numbers
Sometimes, you may want to choose from
several long distance carriers when you send
a fax. Rates may vary depending on the time
and destination. To take advantage of low
rates, you can store the access codes of long-
distance carriers and credit card numbers as
One Touch and Speed Dial numbers. You
can store these long dialing sequences by
dividing them and setting them up as
separate One Touch and Speed Dial
numbers in any combination. You can even
include manual dialing using the dial pad.
(See Storing One Touch Dial numbers or
Storing Speed Dial numbers in chapter 7 of
the Basic User's Guide.)
For example, you might have stored '555 ' on
Speed Dial: 03 and '7000' on One Touch: 02.
You can use them both to dial '555-7000' if
you press the following keys:
a
Press (Phone Book).
b
Press a or b to choose Search.
Press OK.
c
Press a or b to choose
Numeric Order.
Press OK.
d
Press a or b to choose #03.
Press OK.
32
Note
One Touch Dial locations begin with l.
Speed Dial locations begin with #.
e
Press OK to choose Send a fax.
f
Press a or b to choose Phone Book.
Press OK.
g
Press a or b to choose Search.
Press OK.
h
Press a or b to choose
5
Numeric Order.
Press OK.
i
Press a or b to choose l02.
Press OK.
j
Press OK to choose Send a fax.
k
Press Black Start or Color Start.
You will dial '555-7000 '.
To temporarily change a number, you can
substitute part of the number with manual
dialing using the dial pad. For example, to
change the number to 555-7001 you could
press (Phone Book), choose Search,
press 03 and then press 7001 using the dial
pad.
Note
If you must wait for another dial tone or
signal at any point in the dialing sequence,
create a pause in the number by pressing
Redial/Pause. Each key press adds a
3.5-second delay.