Advertisement
Step 12
IMPORTANT: You will need someone's help in this step.
å
Fasten the TOP (I) to the ENDS (A and B). Use ten BLACK 9/16" LARGE HEAD SCREWS (1S) through the LIFT TABLE
å
MECHANISMS (23M) and into the holes in the ENDS.
NOTE: Be careful when lining up the holes in the MECHANISMS with the holes in the ENDS as to not damage any parts.
å
You should start each SCREW a few turns before completely tightening any of them.
Do not insert
SCREWS into
these holes.
I
23M
A
23M
Do not insert
SCREWS into
these holes.
BLACK 9/16" LARGE HEAD SCREW
(10 used in this step)
These four holes
must be here.
B
1S
Advertisement
