Be Cool BCRS2102F Instruction Manual page 30

2. Disconnect the unit from the filter housing
Separate the housing from the filter holder by
grasping the unit by the handle and pulling it
upwards.
3. Cleaning the HEPA filter
Remove the filter from the housing.
Remove dust and other dirt using a hoover.
Never use water to clean the filter.
4. Cleaning the filter housing
Clean the filter housing with a brush and a soft,
damp cloth.
You can remove the dust beforehand with a
hoover.
Make sure that the housing is completely dry
before you reassemble the parts.
5. Assembling the parts
Put the filter back into the filter insert.
Then lift the unit by grasping the handle and
place it back on the filter housing.
Make sure that the "FRONT" marking on the filter
housing is also on the front of the unit.
Finally, tighten the two screws on the housing.
Seite 30 von 33