Spare Parts Replacement; Instructions For The User - OEM AS/T Operating And Service Manual - Spare Parts

4 - SPARE PARTS REPLACEMENT

- ELECTRICAL COMPONENTS OF THE DOUGH ROUNDER:
The access to all the components is easy, after removing the machine bottom.
- MOTORS
Removing the dough rounder bottom, you can reach the motor.
- REPLACEMENT OF THE BELL
Release the bell, turning it counterclockwise. After removing eventual dough
residual parts, insert the new "bell", turning it clockwise until its hooking.
The disk shall absolutely not touch the lower part of the bell
Foe a correct functioning, we suggest a distance (clearance) measuring 3 mm
between disk and bell (TABLE A ).
WARNING: Assure that there is always such distance, for all the hookings (n° 3) positioned
at 120°C, otherwise you do not achieve parallelism between the fixed surface (bell)
and the revolving surface (disk)
For adjusting the "clearance" between disk and bell, loosen the nut A (self-locking
nut) fig. 3 ) position the bush B again, which determines a correct positioning (verify
with a 3 mm-thickness gauge.
Lock the bush with the nut A, keeping it in this position through a suitable punch
in the relevant holes.
The installation of the machine shall be carried out in a suitable way, the user shall check
it; the manufacturer disclaims all responsibility for guarantees or damages resulting from
a wrong installation, imperfect maintenance, improper use.
Before starting the AS/T machine, carefully read the instructions contained in this
handbook, taking particular care to the rules regarding the safety devices.
Always switch off the cut-out switch at the end of any machine utilization , especially
during maintenance and repair procedures. The machine shall only be used considering
the aim it has been developed for, that is to say:
PIZZA DOUGH ROUNDER.
The machine shall be utilized in compliance with the rules and it shall also carefully be
cleaned.
All the safety devices shall constantly be effective..
Changes or applications on the machine of devices are not allowed and would determine
the cessation of any guarantee performance.
5 - UTILIZATION OF THE MACHINE - FIG 1
Press the running push-button.
When the machine runs, insert a dough portion in the relevant funnel, taking it
then rounded at the outlet, as per figure 1
10

INSTRUCTIONS FOR THE USER

AS / T