TechniSat TECHNIPOLAR 2 M Instruction Manual page 43

6.5 Fan mode
If you use the unit in this mode, the exhaust hose does not need to be connected.
> Press the MODE button (6) several times until Fan (A) lights up. Press the
FAN SPEED button (2) several times to select the desired fan speed - High,
Medium, or Low can be selected.
Automatic control is not available in this mode.
6.6 Automatic mode
In automatic mode, the unit independently decides which mode to use based on
the current room temperature:
- Between 20 °C and 23 °C
- Room temperature over 23 °C
> Press the MODE button (6) several times until all mode LEDs are switched off
and a rotating bar appears on the display.
> Press the FAN SPEED button (2) several times to select the desired fan speed
- High, Medium, or Low can be selected.
7 Timer mode
The timer can be used to automate switching the unit on or off.
Efficient use of the timer mode saves electricity, since the unit is only in operation at
the set times.
7.1 Programming the timer
Delayed switching on
> First select the mode and the desired settings (fan speed, temperature) while
the unit is in operation. Then switch off the unit.
> With the unit is switched off, press the TIMER button (1). The timer LED (D)
and the number of hours flash on the display.
> Within 5 seconds, press the TIMER button again several times to set the
hours by which you want to delay switching on the unit.
The timer can be set in 1-hour intervals from 1 hour up to 24 hours.
= Fan mode
= Cooling mode
DE
EN
PL
NL
43