TechniSat TECHNIPOLAR 2 M Instruction Manual page 41

6.3 Cooling mode
The unit is ideal for hot, humid weather when it comes to cooling and dehumidifying
the room Dehumidify at the same time.
> Press the MODE button (6) several times until "Cool" (A) lights up.
> Select the target temperature (18 °C to 32 °C) by pressing the Temperature
selection warmer / cooler (3, 5) buttons until the corresponding value is
shown on the display.
After switching on the unit and activating the cooling function, it may take a
moment for the compressor to start and the unit to start to cool.
> Press the FAN SPEED button (2) several times to select the desired fan
speed, whereby High, Medium, Low and Auto (automatic control) can
be selected. Depending on the fan speed selected, the noise level of the
air conditioning unit while in operation will also change. If you prefer the
quietest possible operation, select Low.
The most suitable temperature for the room during the summer is between
24 °C and 27 °C. However, it is recommended not to set a temperature that is
far below the temperature outside.
Both drain caps (11, Upper condensate drain, 12 Lower condensate drain)
should be closed in this mode to enable efficient cooling. The condensed
water produced is collected in the unit tank.
DE
EN
PL
NL
41