TechniSat TECHNIPOLAR 2 M Instruction Manual page 40

6 Operation
The control panel is located on the top of the unit.
However, you need to use the remote control in order to utilise the full potential of
the unit.
6.1 Control panel
A LED of the selected operating mode
B LED of the selected fan speed
C LED if the sleep timer is active
D LED if the timer is active
1 Enable timer
2 Blower level
3 Temperature selection (cooler)
4 Display
5 Temperature selection (warmer)
6 Operating mode
7 On/Off
6.2 Switching on and off
Insert the plug into the wall outlet. "- -" appears on the display.
Press the On/Off button (7) once to switch on the unit.
Press the On/Off button again to switch the unit off.
Never turn off the air conditioner by pulling out the power plug. Always turn
off the air conditioner first by pressing the On/Off button and wait a few
minutes before unplugging it. This allows the unit to perform a check cycle
and shutdown properly.
Do not switch the air conditioner back on immediately after switching it off -
wait a few minutes.
40