Parts Removal & Replacement - Signode PSD-109 Operation, Parts And Safety Manual

PARTS REMOVAL AND REPLACEMENT
WEAR SAFETY GLASSES WITH SIDE SHIELDS WHICH CONFORM TO ANSI STANDARD
Z87.1. FAILURE TO WEAR SAFETY GLASSES COULD RESULT IN SEVERE PERSONAL
INJURY. PROTECT YOUR EYES. READ GENERAL SAFETY INSTRUCTIONS IN THE FRONT
OF THIS MANUAL
• Only trained people should service machine
• Unless specified, shutoff and lock out all electrical power.
• Follow all service instructions.
• Use Correct tools.
• Never adjust, repair or oil moving machinery
BRAKE BLOCK
To remove and replace the brake block:
1. Lift the dancer arm and hang it on the
lacing hatch. This will discharge the
brake.
2. Disconnect the extension spring (1) at the
S-hook (2) on the brake lever (3).
3. Remove the 1/2-20 stop nut (4), the hex
head cap screw (5), the flat washer (6) and
the worn brake block (7) from the brake
lever.
4. Install the brake block and reassemble all
parts. At this point, just snug the stop nut.
5. Turn the brake block so that the rolled
edge of the inner flange will make as much
contact with the brake block as possible.
6. Attach the extension spring to the S-hook.
7. Tighten the stop nut until the brake block
is firmly held between the flat washer and
brake lever.
8. Release the dancer arm and return the lacing latch to its storage position on the upper arm.
9. Readjust the brake block pressure, if needed. Refer to the Adjustments Section for details.
9