Operation - Signode PSD-109 Operation, Parts And Safety Manual

COIL LOADING INSTRUCTIONS, Continued
8. Guide strap back up and over the next roller on the upper roller stack, (3). Repeat this
process until all the rollers are loaded. The lead end of the strap should terminate at the
innermost upper arm roller, (4).
9. Hold on to the strap lead end and release the dancer arm latch. The spring loaded dancer
arm will return to its lower position and the strap is ready to be inserted into the machine.
Return the lacing latch to its storage position on the
upper arm.
STRAP IN THE DISPENSER
Strap threading can be simplified if the dispenser is
reloaded just before the coil runs out.
1. Re move the strap from the strapping machine and
make sure the dancer arm is in its lowermost
position.
2. Cut the strap at the coil and follow steps 1,3, and 5,
Method One, to load a new coil on the dispenser.
3. Tape the lead end of the new coil to the trailing end
of the old strap and manually draw the new strap
through the roller stacks.
4. Remove and discard the old strap and the tape. Tape must not be allowed to enter the
strapping machine,
5. Insert the new strap into the strapping machine.
DISPENSER OPERATION
As strap is drawn from the dispenser, the dancer arm is raised and the flange brake is released.
The multi-roller design permits the strap coil to accelerate smoothly to full speed and strap is
dispensed. When strap demand is complete, the dancer arm returns to its lowermost position.
The brake is engaged, the strap coil stops rotating and the excess strap is accumulated within
the multi-roller configuration.
6