Communications Language
There are two different communications settings for the Scout. After power up the words Scout are dis-
played followed by the current communications language. Following is a list of the communications
language and a brief description of when to use each particular setting:
CI-5
AOR
CHANGING COMMUNICATIONS LANGUAGE
To change the communications language follow the procedure below.
1.
When powering the Scout on make sure that the FILTER and CAPTURE switches
are in the ON position, or up.
2.
Just after switching the power on, slide the CAPTURE switch to the OFF position, or
down. As the Scout continues to go through its power up routine it will display the
new communications language. If the language did not change repeat steps 1 and 2.
11
For use when Reaction Tuning the following ICOM receivers: R10,
R7000, R7100, R8500, and R9000. Radio Shack PRO 2005/2006 (with
OS456/Lite installed),PRO 2035/2042 (with OS535 installed),
R11&OptoCom
For use when Reaction Tuning the AOR AR8000 or AR8200.
Need help?
Do you have a question about the Scout and is the answer not in the manual?