REACTION TUNE
When the Scout is in FILTER mode or CAPTURE mode it can Reaction Tune a receiver connected to the
serial interface of the Scout. Following are the procedures for Reaction Tuning the various receivers that
are compatible with the Scout.
CI-5
1. Upon powering the Scout on, the LCD will display the words Scout followed by the current communi-
cations language. Confirm that the Scout displays CI-5. If the current setting is not the desired
setting refer to the COMMUNICATIONS LANGUAGE section of this manual for information on
how to change to the desired setting.
2. Following are the current CI-5 compatible receivers that the Scout is capable of Reaction Tuning.
ICOM R10, R7000, R7100, R8500 and R9000. Also, the Radio Shack PRO 2005/2006
(with OS456/Lite installed), Radio Shack PRO 2035/2042 (with OS535 installed) and the
Optoelectronics R11 and OptoCom.
The ICOM R10 and R7100 require special default settings for Reaction Tuning with the Scout.
ICOM R10:
ICOM R7100: Baud Rate = 9600, Transceive Mode = ON
3. Attach the 3.5mm portion of the CB-CI5 cable (optional) into the Radio Remote jack on the (R7000,
R7100 and R9000) and the CI-V jack on the R10 and Radio Shack models. Attach the 2.5mm portion
of the cable into the CI-V jack located on top of the Scout.
Baud Rate = 9600, TRN = ON, CI-V ADDRESS = 52
Operation (Reaction Tune)
16
Need help?
Do you have a question about the Scout and is the answer not in the manual?