Table of Contents
Advertisement
S1 S2
6
Checking twilight sensor operation
S1 S2
1
2
If it is daytime and you want to check AUTO mode operation for the twilight sensor, you can proceed as follows:
1. Enter programming mode
2. Block the twilight sensor for 5 seconds
»
If AUTO mode has been set, the camera and button LEDs will come on.
3. Exit programming
24
Reset the configuration of the
DIP-switches
7
5 sec
S1 S2
3
Advertisement
Table of Contents
Need help?
Do you have a question about the Simplebus1 Ultra UT1010 and is the answer not in the manual?