Table of Contents
Advertisement
Twilight sensor
Button backlighting management
The twilight sensor
is in AUTO mode by default:
the LEDs light up at night
and switch off during the
day. To change the setting to
ON (LEDs always on) or OFF
(LEDs always off), proceed
as follows:
3
ON
1
1 2 3 4
5
6 7
8
example:
code 159
5
NOTE: when the OFF and AUTO lighting modes are active, every time the entrance panel is powered, the
buttons light up for the duration of the start-up phase (10 seconds maximum).
In AUTO mode the twilight sensor checks the ambient light level every 9 minutes; if the measured values
exceed the specified minimum/maximum thresholds, it is activated/deactivated accordingly.
LL
1
S1 S2
4
1. Set the desired backlighting mode (OFF, ON or AUTO)
2. Press the confirm button
ON
1 2 3 4
2
Take note of the DIP-switch
settings
2
OFF
ON
ON
5
6 7
8
1 2 3 4
cod. 158
cod. 159
ON
OFF
1 2 3 4
5
6 7
8
AUTO (default)
ON
5
6 7
8
1 2 3 4
5
6 7
cod. 160
8
23
Advertisement
Table of Contents
Need help?
Do you have a question about the Simplebus1 Ultra UT1010 and is the answer not in the manual?
Questions and answers