Brother FAX-T104 User Manual page 107

3
Take the used ribbon out of the cartridge:
1 Snap out the upper and lower right white spools.
2 Slide the roll off the blue gear and lower left white spool.
(Do not remove the blue gear and lower left white spool).
Blue
Gear
White
Spool
(Do not
remove.)
4
Slide the white elastic off the new refill rolls and set them down
with the full roll in the lower position. (The ribbon's shiny side
is facing down.)
5
Remove the white spools from the ends of the used cardboard
cores. Then insert them into the same positions in the new
cores.
6
Install the new ribbon in the cartridge:
1 Slip the lower left cardboard core onto white spool of the
cartridge and then slip the upper blue core onto the blue
gear of the cartridge.
2 Insert the upper and lower right white spools into the
holders.
Blue
Gear
White
Spool
Insert the teeth of the white spool into the cutouts of the
cardboard core.
Troubleshooting and routine maintenance
Used Ribbon
Upper White Spool
Lower White
Spool
Cartridge
White Spools
Shiny side is face down.
White Spools
13 - 10