Chapter 18: Replacing The Power-Button Board; Procedure; Post-Requisites - Dell 3000 Series Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
•

Procedure

•

Post-requisites

Procedure
1. Slide the power-button board under the tab on the palm-rest assembly and align the screw hole on the power-button board
with the screw hole on the palm-rest assembly.
2. Replace the screw that secures the power-button board to the palm-rest assembly.
3. Adhere the tape that secures the power-button board to the palm-rest assembly.
4. Adhere the power-button board cable to the palm-rest assembly.
5. Slide the power-button board cable through the slot on the palm-rest assembly.
6. Turn the computer over and open the display as far as possible.
7. Slide the power-button board cable into its connector on the system board and close the latch to secure the cable.
Post-requisites
1. Follow the procedure from step 3 to step 7 in
2. Replace the keyboard.
3. Follow the procedures from step 4 to step 5 in
4. Replace the battery.
36 Replacing the power-button board
Replacing the power-button board
computer. After working inside your computer, follow the instructions in
"Replacing the base
"Replacing the optical
cover".
drive".
18
After