Razor FLASHBACK Owner's Manual page 10

REPAIR AND MAINTENANCE
Replacing the Rear Wheel
Required Tools: 10 mm Wrench and Two (2) 16 mm Wrenches (included)
1
Loosen the brake clamp nut with
a 10 mm wrench.
4
Tighten the axle nuts using
two (2) 16 mm wrenches.
Cleaning Your Scooter
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the
surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic
components or soften the decals or decal adhesive.
Wheels and Bearings
It is the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axles for
proper tightness, and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops
play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine
Razor replacement wheels. Worn wheels/bearings are considered normal wear and tear and are not covered by the
Warranty. Other manufacturers' wheels may not be compatible with your Flashback scooter, may affect your safety
and will void your warranty.
Replacement Parts
The most frequently requested replacement parts are available for purchase at some Razor retail partners.
For the complete selection of replacement parts visit www.razor.com.
Repair Centers
For a list of authorized Razor repair centers:
• Check online at www.razor.com.
• Additional Customer Service contact information is listed at the back of this manual.
2
Remove axle nuts from the
axle bolt using two (2) 16 mm
wrenches and remove the wheel.
5
Press both sides of the brake
clamp inward until it is close to the
wheel hub. Keep both sides of the
clamp motionless while pulling the
brake cable back. Tighten the nut
with a 10 mm wrench.
B
B
A
3
Insert the replacement wheel
into the rear fork and insert the tab
on the washers (A) into the holes
(B) on the rear fork. Safety washers
should be on the outside of the fork
facing the tire.
8
WARNING: Failure to
properly install the rear wheel may
cause the rider to lose control and
fall. If you are having difficulty
understanding these instructions,
A
please contact Razor Customer
Service for assistance.