Exmark Radius X Series Operator's Manual page 12

Safety
1. Read the instructions before servicing or performing
maintenance
2. Time interval
3. Check oil level
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the
maximum recommended slope indicated on the decal. It is important that each operator review the slope operation
instructions in the operator's manual and review the conditions in which the machine is being operated to determine
if the machine may be operated in the conditions that day and on that site. Changes to terrain can result in a
1. Warning–Read the Operator's Manual. Do Not operate this
machine unless you are trained. Wear hearing protection.
2. Cutting and pinching hazard–keep hands and feet away
from moving parts; keep all guards and shields in place.
3. Ramp hazard–when loading onto a trailer, Do Not use
dual ramps; only use a singular ramp wide enough for the
machine and that has an incline less than 15 degrees;
back up the ramp (in reverse) and drive forward off the
ramp.
126-8151
4. Refer to the Operator's manual for grease instructions
5. Check hydraulic oil level and refer to the Operator's
6. Check tire pressure
126-8383
change in slope operation for any machine.
4. Bodily harm hazard–Do Not carry passengers. Look
5. Thrown object hazard–keep bystanders away.
6. Tipping hazard on slopes–Do Not use on slopes near open
12
manual or further instructions
behind you when mowing in reverse.
water; Do Not use on slopes greater than 15 degrees.
decal126-8151
decal126-8383