English - Braun Oral-B OxyJet MD 15 User Manual

English

The Braun Oral-B OxyJet
into water in the form of micro-bubbles. These
micro-bubbles in the water stream attack
plaque bacteria.
At the same time, it removes remaining food
particles from between your teeth and
massages your gums. Always use the irrigator
after brushing your teeth.
Please read the use instructions carefully
before first use.
Important
The plug should always be accessible.
Periodically check the cord for damage.
Should this be the case, take the appliance to
a Braun Service Centre. A damaged or non-
functioning unit should no longer be used.
Description
a Irrigator jet
Jet switch
b
Jet compartment
c
Jet release button
d
On/off switch
e
Water pressure control dial
f
g Sliding switch (water stop and go)
Irrigator handle
h
Water container (600 ml / 20 fl. oz.)
i
Specifications
Power supply: see bottom of housing
Power intake: 24 W
6
®
irrigator mixes air
Using the OxyJet
Before using for the first time, fill the water
container and allow the water to run through
completely by holding the irrigator handle
over a washbasin.
1. Attach one of the irrigator jets to the
handle until it locks in place. Fill the water
container with water and add mouthwash,
if desired.
2. Turn on the irrigator by pressing the on /off
switch. ( When doing so, the sliding switch
on the handle should not be pushed up.)
3. Select the water pressure with the
pressure control dial ( 1 = gentle,
5 = strong ). We recommend that you start
with setting 1, especially if your gums tend
to bleed or if children are using the irrigator.
4. Bend over the wash-basin and guide the
jet to your teeth and gums. Slide the
handle switch up to start the water stream.
Keep your mouth slightly open to allow the
water to run into the washbasin.
You can choose between two different jet
functions by sliding the jet switch down
or up (before doing so, turn off the water
stream by pushing the sliding switch down):
®
Irrigator