Overhead Mounting; Floor Mounting - Chauvet DJ SlimPAR PRO Pix Quick Reference Manual

EN
To Begin
Unpack your SlimPAR Pro Pix and make sure you have received all parts in good condition. If the box or contents appear
damaged, notify the carrier immediately, not Chauvet.
AC Power
This product has an auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Power linking
You can link up to 6 SlimPAR Pro Pix products at 120 V or 11 products at 230 V. Never exceed this number. Power-linking
cords can be purchased separately.
Fuse replacement
1. Disconnect the product from power.
2. Wedge the tip of a flathead screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the
Mounting diagram

Overhead Mounting

2
QUICK REFERENCE GUIDE
Safety Notes.
Mounting clamp
(such as CLP-15 from Chauvet)
Safety cable
(such as CH-05 from Chauvet)

Floor Mounting

SlimPAR Pro Pix QRG Rev. 1