Cleaning And Maintenance; Troubleshooting - Yoer MG01S GRINDO Manual

CLEANING AND MAINTENANCE

CAUTION:

Before commencing any of the activities described below, unplug the device.

The device should be cleaned immediately after finishing work as dried up food remains may cause
the accessories to become difficult to disassemble and make the cleaning process difficult.

Do not use erosive cleaning agents to clean any parts of the device.

Do not wash any parts of the device in a dishwasher.

After each cleaning, put a thin layer of vegetable oil on the cutting knife and plates.
1. Remove all accessories used and disassemble them completely.
2. Wash each part with warm water and some dishwashing liquid.
3. Rinse each part with warm, clean water.
4. Thoroughly dry off all parts.
5. Use a damp cloth to clean the body of the grinder, and then dry it off thoroughly.

TROUBLESHOOTING

Problem
The device does not work
Grinding chamber or
cutting chamber falls out
of the chamber socket
Food is not coming out
the outlet port
The device is grinding
poorly
The grinder turns off
during operation
ENGLISH
Possible cause
The power plug is
disconnected from the wall
socket.
The accessories are
improperly installed.
The device is clogged.
The power setting is too
low.
The meat was not cleaned
off and/or the pieces are
too large.
The cutting knife was
installed on the wrong
side.
The grinder has
overheated.
The cutting knife or other
part has worn out.
The grinder was used for
too long.
The meat was not cleaned
off and/or the pieces are
too large.
The device is damaged.
Connect the power plug to the wall socket.
Remove the accessories and install them
properly.
Set the control switch in the "REV" position until
the grinding chamber clears.
Take the juicer off and remove excess pulp.
Set the control switch in the "2" position.
Clean off the meat and/or cut it into smaller
pieces.
Install the cutting knife with the convex side
facing inwards to the device.
Turn the grinder off, unplug it and let it cool
down for at least 60 minutes.
Replace the worn out part with a new one
recommended by the manufacturer.
Turn the grinder off, unplug it and let it cool
down for at least 60 minutes. Do not operate the
device for longer than 5 minutes at a time.
Clean off the meat and/or cut it into smaller
pieces.
Unplug the device and contact customer service.
22
Solution