Yoer MG01S GRINDO Manual page 17

CUTTER
Accessory installation
CAUTION: Before commencing any of the activities described below, unplug the device.
1. Set the device on a flat, stable surface.
2. Pull the locking handle upwards. Slide the cutting chamber into the chamber socket. Make sure it is
installed vertically and to the end – if it is possible to rotate it, it means it has not been installed properly.
3. While holding down the cutting chamber, pull the locking handle all the way downwards.
4. Put the chosen grater in the cutting chamber and twist it until it locks into place.
5. Insert the cutter food pusher into the opening at the top of the cutting chamber.
Cutting
CAUTION
Be especially careful when using the cutter, because its grate remains uncovered during operation.
Do not put fingers or any other body parts, or objects into the hopper or the outlet port.
1. Plug in the device.
2. Turn on the device by setting the control switch to the "1" or "2" position.
3. Remove the food pusher, feed products into the hopper and push them in with the food pusher.
4. Set the control switch in the "OFF" position and unplug the device when you are done cutting.
Useful information: The cutter may also be used to prepare potato pancake pulp, potato dumplings etc.,
as well as grind down vegetables, fruit, or prepare chocolate or coconut chips.
ENGLISH
17