Control Switch; Technical Specification; Using The Device - Yoer MG01S GRINDO Manual

CONTROL SWITCH

TECHNICAL SPECIFICATION

Nominal power
Locking power
Voltage / Frequency

USING THE DEVICE

Wash the device and its accessories thoroughly before first use.
CAUTION
IMPORTANT:

Use the device for a maximum of 5 minutes at a time. Allow the unit to cool down for 10 minutes between
each 5-minute use.

The grinding chamber auger is larger than the juicer auger, and is equipped with an aluminum clutch
at its end.

If the unit clogs up during operation, set the switch in the "REV" position until the grinding chamber
clears.

If it becomes noticeably difficult for the device to grind, shred or juice products, set the switch
in the "2" position to increase power.

The supplied lid can be used as a bowl for prepared products.

A groove for the power cord is located at the bottom of the grinder body. While setting it down, make
sure the cord is placed in the groove because, if positioned improperly, it will make it impossible for the
grinder to be set in a stable position.

The power cord can be stored on the cord roller located at the bottom of the grinder after use.
DO NOT PUT FINGERS OR ANY OTHER BODY PARTS INTO THE GRINDING
CHAMBER, OUTLET PORT, OR ANY OTHER OPENINGS ON THE DEVICE
OR INSTALLED ACCESSORIES DURING OPERATION, OR WHEN THE DEVICE
IS TURNED OFF BUT REMAINS PLUGGED IN, BECAUSE IT MIGHT CAUSE
SERIOUS BODILY HARM. USE THE SUPPLIED FOOD PUSHERS TO FEED
PRODUCTS INTO THE CHAMBERS.
ENGLISH
"OFF" position – the device is turned off
"1" position – low speed
"2" position – high speed
"REV" position – reverse
800W
1900W
220-240V~ 50/60Hz
15