Troubleshooting - Bissell PROHEAT 2X REVOLUTION PET 2066F User Manual

Troubleshooting

WARNING
disconnect plug from electrical outlet before performing maintenance or troubleshooting.
Problem Possible causes
Clean Water Tank may be empty.
Reduced or no
spray through
Clean Water Tank may not be
Foot of machine
seated completely.
The hose to your machine is not
primed or may have lost prime.
No spray
through hose
& tool
Clean Water Tank may be empty.
Clean Water Tank may not be
seated properly.
Clean Water Tank may be empty.
Clean Water Tank may not be
seated properly.
No spray
through
The machine is not reclined.
CleanShot
Pump may have lost prime.
CleanShot
CleanShot button is not in the off
continues spray position.
when machine
is OFF
Dirty Water Tank may not be seated
properly.
Dirty Water Tank has picked up
maximum amount of dirty water
and has reached the full line.
Rubber Tab on Dirty Water Tank is
Loss of suction
not sealed tight.
power
Accessory Hose Door may not be
closed tightly in place.
Nozzle may be clogged from pet
hair or debris.
Brush Roll cover not fully snapped
into place.
Cleaning Mode Switch mistaken for
Power Switch.
No power
Outlet may not be active.
Tank may have been overfilled.
Water may be caught in space
Leaking tank
between the tank and the tank's
handle.
To reduce the risk of fire, electric shock or injury, turn power OFF and
Remedies
Refill tank.
Turn power OFF. Remove and reseat tank.
1. With the machine OFF and unplugged, remove the nozzle from the Foot. Place a ballpoint pen in the black
cylinder next to the screw. When water bubbles up, remove the pen. Reassemble the nozzle and hose.
2. Hold end of hose below water level in tank to prime.
3. With the Clean Water Tank full of water, the machine OFF and RECLINED, press the CleanShot button ON
and wait for the CleanShot to drain for a few seconds. This will re-prime the machine.
Refill the tank.
Turn power OFF. Remove and reseat the tank.
Refill the tank.
Turn power OFF. Remove and reseat the tank.
Press the Recline Pedal and bring the handle down to recline the machine.
With the machine OFF and unplugged, remove the nozzle from the Foot. Place a ballpoint pen in the black
cylinder next to the screw, when water bubbles up, remove the pen, reassemble the nozzle before
cleaning again.
Press the CleanShot button to turn it off. The button window will show the colour red and a "O" symbol
when it is in the off position.
Pick up the tank and reseat so it fits in the machine.
Empty tank.
Check the Rubber Tab on the tank and press firmly on all edges to secure it tightly
(see step 4 on page 11 for detail).
Check the Accessory Hose Door and make sure it is closed tightly – it should be locked into place.
Use the Nozzle Clean Out Tool and follow steps on page 12 for "Maintaining the Brush Roll & Nozzle".
Remove and replace the nozzle and Brush Roll cover; Follow step 6 from page 12 and make sure you
hear both buttons click into place.
Flip the Power Switch on the left side of the machine to turn it ON.
Try plugging in a different device that uses a grounded outlet to test for power from the outlet.
1. Make sure your tank has the water and formula in it that you've prepared.
2. With the cap twisted on tightly, hold your tank at an angle, over a sink or drain, so any extra water can
pour out of the space.
3. Wipe the tank dry with a cloth.
15
BISSELL.com