PC Elite Reference
___________________________________________ _
Installing The PC ELITE Board In The Computer.
NOTE: Always turn the computer OFF before installing or
removing any interface board from the computer.!!!
After having made sure that the i/o address and the IRQ
and DMA jumpers are correctly set now is the time to insert the
PC ELITE card into the i/o connector slots in the computer.
STEP 1 Before the PC ELITE IEEE board can be installed
the power to the PC MUST be switched OFF!
Figure 2-6. Remove Cover Mounting Screws.
______________________________________ _
________________________________
Figure 2-7. Removing The PC Cover.
STEP 3 Next, remove the PC's cover by sliding it forward and
up. It usually helps to disconnect the keyboard from the PC
since it tends to get in the way when the case is removed.
2-18
Installation Guide
STEP
2
using
a
driver, remove the
cover
mounting
screws on the back
panel of the PC
system unit.
Chapter 2
Then
screw