Table of Contents
Advertisement
Installation Guide
IRQ14 is the AT/386/486 hard disk interrupt.
When in PC2a compatible mode the position of the jumper
MUST match the IRQ level set in the software and the IRQ
acknowledge address set on DIPs 4-6 and IRQ choices are thus
restricted to IRQ2-7.
If in doubt leave in the jumper in the factory set condition,
interrupt 7.
________________________________
Setting The Interrupt Clear Address.
When in PC2a mode the interrupt clear address on DIPs 4-
6, must be set correctly if the interrupts generated by the ELITE
card are to properly serviced by your software. Whilst DIP
switches 4-6 can be used to select one of 8 different interrupt
clear addresses they should only be set to one of the six valid
addresses and the IRQ jumper MUST be set correspondingly.
When in PC2 mode, DIP 3=ON, then DIPS 4-6 have no
effect.
Figure 2-4. The PC2a Mode IRQ Clear Address.
_________________________________________ _
DIP 4 DIP 5 DIP 6
_____ _____ _____
Off
Off
Off
On
Off
Off
Off
On
Off
On
On
Off
Off
Off
On
On
Off
On
Off
On
On
On
On
On
DMA Selection.
_____________ _
The PC ELITE card can perform its input or output under
DMA control, that is the data moves between the PC and the
IEEE devices in the background whilst the computer is
Chapter 2
_______________________________
Interrupt as selected by jumper
0 Not Valid DO NOT USE THIS SETTING !
1 Not Valid DO NOT USE THIS SETTING !
2 Place jumper at Interrupt 2
3 Place jumper at Interrupt 3
4 Place jumper at Interrupt 4
5 Place jumper at Interrupt 5
6 Place jumper at Interrupt 6
7 Place jumper at Interrupt 7 THE DEFAULT.
PC Elite Reference
__________
PC2A Only
2-15
Advertisement
Table of Contents
