Good Earth Lighting UC1229-RPW-18LF5-G Manual

5.0 Bluetooth speakers
Haut-parleurs Bluetooth 5.0
Parlantes Bluetooth 5.0
Power/linking outlet
Prise de courant pour raccordement
Tomacorriente/salida de enlace
Diffuser
Diffuseur
Difusor
READ ENTIRE INSTALLATION PROCEDURE BEFORE YOU BEGIN!
DO NOT USE THIS FIXTURE WITH A DIMMING CIRCUIT.
SHUT OFF POWER TO THE OUTLET PRIOR TO
INSTALLING THE FIXTURE. DO NOT ATTEMPT
TO INSTALL FIXTURE WHILE PLUGGED-IN TO
POWER SUPPLY.
Suitable for INDOOR damp locations ONLY.
This fixture can ONLY be linked with Good Earth
Lighting models UC1230-RPW-18LF5-G and
UC1230-RPW-24LF7-G
DO NOT ATTEMPT TO INSTALL LED LIGHT BAR WHILE PLUGGED IN.
AA x4
BBx2
NOTE: Ensure mounting location is within
5ft. of an electrical outlet and that there is
enough space on backside to plug in the
power cord.
Mark the general area where the mounting brackets (BB) will be located. Using a small drill or nail, make two small pilot holes at the marked locations. Align the mounting
brackets (BB) and drive screws (AA) into place. NOTE: Ensure mounting location is within 5ft. of an electrical outlet and that there is enough space on backside to plug in the
power cord and/or linking cord.
With the USB ports facing outward, lift the fixture toward the mounting brackets (BB) while aligning the top of the fixture channel with both clips. Apply upward pressure until
channel snaps into place and seats into both brackets.
Plug into outlet. Use included cord clips (CC) for cord management.
Luminaire pour dessous de meuble avec haut-parleurs Bluetooth
USB ports
Ports USB
Puertos USB
USB ports
Wave sensor
Ports USB
Capteur d'ondes
Puertos USB
Sensor de ondas
WARNINGS AND CAUTIONS
IMPORTANT SAFETY INFORMATION
1. Use ONLY insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged.
3. LED light output is strong enough to injure human eyes. Do NOT look directly at exposed LEDs.
4. LEDs gradually emit less light over their lifetime.
5. Do NOT use with an extension cord, use ONLY with power strips that have integral overcurrent protection.
6. Do NOT mount to surfaces less than ¼ in.
7. Do NOT mount over sinks or stoves.
8. Do NOT install these lights inside of enclosed cabinets.
9. Turn power off before servicing.
10. Maximum number of fixtures per run must NOT exceed maximum power supply wattage rating of 240W.
11. NOT intended for recessed installation in ceiling or soffits.
LED Bluetooth
Luz LED para debajo de gabinetes con parlantes Bluetooth
Model / Model / Modelo #: UC1229-RPW-18LF5-G
Linking cord
Cordon de
raccordement
18in. / 45,7 cm
Cable de enlace
60in. / 152,4 cm
Power cord
Cordon d'alimentation
Cable de alimentación
ATTACH AND SAVE RECEIPT HERE
Speaker Under Cabinet Light (Page 1)
®
à DEL (Page 3)
®
Hardware kit* /
Trousse de quincaillerie* /
Kit de aditamentos*
AAx4 BB x2
* Actual hardware may differ from illustration
* La quincaillerie incluse peut être différente de
l'illustration.
* Los aditamentos reales pueden diferir de los que se
muestran en la ilustración.
Required/ Nécessaire/ Obligatorio
CCx5
Avoid putting nails through the cord.
(Página 5)
®
CCx5