Table of Contents
Advertisement
INSTALLATION
5.1
Hydraulic System Requirements
IMPORTANT - Vanair
specifying the correct hydraulic pump size and type, oil reservoir size, hydraulic cooler,
hydraulic pressure relief, and other hydraulic supply components for your application.
Please take into consideration the following:
The hydraulic flow and pressure requirements of the air compressor.
Keep in mind that when the compressor is running there is a continuous hydraulic
load.
The duty cycle and ambient operating temperatures.
Other hydraulic equipment which may share that same hydraulic supply system
(Vanair recommends a dedicated pump and hydraulic circuit).
NOTE – The temperature of the hydraulic oil should not exceed 140ºF due to the rating
of the Vanair supplied hydraulic motor.
5.2
Installation
Refer to Section 5.4 for dimensions. A location on the truck is the first thing that needs to
be determined. Some of the concerns that need to be taken into consideration include:
There must be enough room around the compressor package to insure proper cooling.
There must be enough room to service the air cleaner, separator element, and oil
filter.
The instrument panel should be readily seen without obstruction for daily operations.
Once a location is found, the compressor package should be mounted down with a
minimum of (4) 1/2-13 capscrews.
The hydraulic hoses must be run into the package to the hydraulic motor. Insure the
hoses are hooked up properly to insure proper rotation. Also, insure that the hoses are
run through an area so that no chafing of the hoses is possible.
The hydraulic compressor package should be wired per wire diagram (Section 5.3).
There are a total of (4) wires to be run inside of the package.
SECTION 5:
INSTALLATION
®
highly recommends consulting a hydraulic supply expert for
Section 5 - Pg 01
Hide quick links:
Advertisement
Table of Contents
