Section 3: Installation; Machine Package Receipt/Inspection; General Instructions - Vanair Reliant RS45 Installation, Operation, Maintenance And Parts Manual

45 cfm/ 150 psig hydraulic-driven, open center & closed center. 12v & 24v, (optional) cold-weather, rotary screw compressor

Hide thumbs

Table Of Contents

Table of Contents

RELIANT RS45 AIR COMPRESSOR

3.1 MACHINE PACKAGE

RECEIPT/INSPECTION

Upon receipt of the machine package,

inspect the exterior of the shipping crate for

signs

shipping/transit

damage should be reported immediately to

the shipping company.

Before fully unpacking the unit, inspect the

component parts, supports and loose-

packed parts to ensure that there have been

no internal movements of assemblies or

components, which may have been

damaged during shipment.

Access the roof panel to inspect the

component parts and supports. Remove

manual from inside of canopy.

Should any damage be discovered during

package inspection, contact the shipping

company immediately.

3.2 GENERAL INSTRUCTIONS

This section provides general guidance for

locating and preparing the Vanair RS45

compressor package for operation. Each

installation is unique and can be affected by

location, ventilation, and other factors such

as electrical and hydraulic power supply

availability and location.

Before performing maintenance or repair

operations on the compressor, ensure that

all power has been removed and locked

out to prevent accidental application.

DO NOT assume that because the

compressor is in a STOPPED condition

that power has been removed.

VANAIR MANUFACTURING, INC.

(844) VAN-SERV • www.vanair.com

SECTION 3:

INSTALLATION

damage.

NOTE

WARNING

090126-OP_r0 (JAN-2018)

Install, operate, and maintain this

equipment in full compliance with all

applicable OSHA, other Federal, state,

local codes, standards, and regulations.

Any

Do not install in any enclosed space

Grounding must consist of a minimum two

(2) gauge wire between the instrument

panel, the machine, and the truck chassis.

Although much of the information given in

this installation section is detailed, these

guidelines should be considered as

referential material only, due to the diverse

possibilities of the end user's vehicle

make, model and year, and the unit model

Install electrical components (circuit

breakers, pressure switches, toggle

switches, etc.) in locations where

exposure to water or moisture will be most

(219) 879-5100 / (844) VAN-SERV

to report missing items, incorrect part

numbers, or other discrepancies.