Scan To Ocr - Brother MFC-8460N Software User's Manual

Scan to OCR

When you choose Scan to OCR, your document will be scanned and sent directly to the Macintosh
designated on your network. ControlCenter2 will activate the OCR software installed on your Macintosh
®
(Presto! PageManager
processing application on the designated Macintosh
(word processing application) on page 161.)
a
Put the document face up in the ADF, or face down on the scanner glass.
b
Press (Scan).
c
Press a or b to choose Scan to OCR.
Press OK.
If your machine is a MFC-8460N or MFC-8660DN, go to Step e.
If your machine is a MFC-8670DN, MFC-8860DN, MFC-8870DW or DCP-8065DN, go to Step d.
d
Press a or b to choose 2sided (L)edge, 2sided (S)edge or 1sided.
Press OK.
Note
If you want to scan a document using the duplex scanning feature, you need to put the document in the
ADF and then choose 2sided (L) edge or 2sided (S) edge depending on your document layout.
e
Press a or b to choose the destination Macintosh
Press OK.
If the LCD prompts you to enter a Pin number, enter the 4-digit Pin number for the destination
®
Macintosh on the control panel.
Press OK.
The machine will start the scanning process.
Note
®
Presto! PageManager
®
) and convert your document into text for viewing and editing from a word
®
or a 3rd Party OCR Software must be installed on your Macintosh
11. Network Scanning (Not available for DCP-8060)
®
. You can change the Scan configuration. (See OCR
®
you want to send to.
11
®
you
®
®
.
179