Monacor JTS CS-W4C/5 Instruction Manual page 26

To exit a menu item without any changes,
press the button EXIT (8)
6) To exit the menu, press the button EXIT or
select the menu item
the knob PUSH / CONTROL
All setting options via the menu can be found in
the following chapters
4.4 Basic settings and reset
1) If it is difficult to read the display, change the
contrast and the brightness
Call up the following menu via
tem Options
Display Options:
Screen Options
Contrast:
Brightness: 5
Turn the knob PUSH / CONTROL to set the
contrast Press the knob to go to
and then set the brightness Press the
ness
button SETUP to save the setting The previous
menu will reappear
To deactivate the menu, press the but-
ton EXIT twice or, to change another setting,
turn the knob PUSH / CONTROL to select the
corresponding menu item and then press the
knob to call it up
2) The brightness of the LED indicators RF
(10) and AF (11) can be set via the menu item
2.Indicator
Indicator
5
3) The antenna inputs (16) are factory-set to sup-
ply a 12 V operating voltage for antenna
amplifiers (e g UB-900I) If no antenna
amplifier is used, deactivate the 12 V operat-
ing voltage via the menu item
:
Power
Antenna Power
ON
OFF
4) Via the menu item
, the output level for the mixed signal
Level
26
and then press
8.Exit
1.Sys-

1.Display Options
5
Fig. 8
Bright-
:
Fig. 9
3.Antenna
Fig. 10
4.Mixed Output
of the microphones at the connections MIXED
AF OUTPUT (20) can be set to line level or
microphone level:
Mixed Output Level
Line
Mic.
for connection to a line level input
Line
for connection to a microphone input
Mic
5) For a reset to the factory settings, select the
menu item
5.Reset
warning the user that the reset will erase any
data stored:
This will erase all data
from receiver's Internal
Storage
Press 2 Sec to Reset
S
To exit, press the button EXIT; to reset, keep
the button SETUP pressed for 2 seconds until
appears
Erasing ...
4.5 Setting the transmission
frequencies for the
four receiver sections
Make sure that the corresponding transmitters
(CS-W4T or other suitable wireless microphones)
are switched off and then set the receiver to an
interference-free transmission frequency There
are different methods to do this:
1 The transmission frequency can be ad-
justed manually between 506 000 MHz and
542 000 MHz (chapter 4 5 1)
2 For operating multiple transmitters at the same
time (chapter 4 5 2), there are 6 groups with
up to 22 channels in each group (see overview
on page 34) In ideal conditions, all channels
of a group can be used for audio transmissions
at the same time
The scan function can be used to deter-
mine the channels being used for transmission
by other systems (chapter 4 5 3) These chan-
nels will be skipped during channel selection
3 Preferred frequencies can also be saved to six
user-defined frequency groups (chapter 4 5 4),
e g for operation in varying locations
Fig. 11
A message appears
Fig. 12