Gas Electric
Refrigerators
Improper installation, adjustment,
alteration, service or maintenance can
cause personal injury or property damage.
Refer to this manual. For assistance or
additional information, contact a qualified
installer, service agency, or the gas
supplier.
Questions?/Des questions?/¿Preguntas? 1-800-444-7210
© 2016 NORCOLD, INC. All rights reserved.
Réfrigérateurs au gaz et
à l'électricité
MODELS / MODÈLES / MODELOS
Une installation, un ajustement, une
modification, une réparation ou un
entretien incorrect peut causer des
blessures ou des dommages matériels.
Consultez ce manuel. Pour obtenir de l'aide
ou d'autres renseignements, contactez
un installateur qualifié, un service de
réparation ou le fournisseur de gaz.
Part No. / N° d'article / Pieza n.° 638360 Rev. A 06.30.2016
Service Manual
Manuel d'entretien
Manual de servicio
Refrigeradores eléctricos y
N180.3
Las alteraciones o los procedimientos
incorrectos de instalación, ajuste, servicio
o mantenimiento pueden causar lesiones
o daños materiales. Consulte este
manual. Para recibir ayuda o información
adicional, póngase en contacto con
un instalador capacitado, empresa de
servicios o proveedor de gas.
de gas
Need help?
Do you have a question about the N180.3 and is the answer not in the manual?
Questions and answers
I have a NorCold 180.3 - the lighter produces a spark but the gas doesn't light. This is not covered in the trouble shouting section. Any assistance would be appreciated
If the gas is not lighting on a Norcold N180.3 even though the lighter produces a spark, possible reasons include:
1. The main gas supply valve is closed.
2. The gas control is set to OFF instead of LO, MED, or HI.
3. The propane gas pressure is incorrect (should be 2.6 - 2.7 kPa or 10.5 - 11.5 inches water column at the tap tee).
4. The tip of the thermocouple is not in the flame or is dirty.
5. The thermocouple is faulty.
6. The exhaust vent is obstructed.
Each of these should be checked and corrected as needed.
This answer is automatically generated
@Mr. Anderson Thanks for your reply! 1) The gas in on; 2) The control is set to high; 3) The gauge on the tank is in green and the stove lights. The thermocouple has been cleaned - though without a flame, there's no heat to register. All vents are clean. Do you have another suggestion?