Seagull Models EXTRA EA300L EP Assembly Manual page 16

EXTRA EA300L EP
ELEVATOR - RUDDER PUSHROD
HORN INSTALLATION.
1) Install the elevator control horn using
the same method as with the aileron control
horns.
2) Position the elevator control horn on
the both side of elevator.
Elevator pushrod.
Elevator pushrod
Rudder pushrod
Nylon Snap Keeper
Nylon Snap Keeper
16
Pushrod Rudder
8mm
1) A scale pilot is included with this ARF. The
Seagull Pilot included fitting well to the cockpit.
(or you can order others scale pilot figures
made by Seagull factory. They are available at
Seagull distributors.)
If you are going to install a pilot figure, please
use a sanding bar to sand the base of the figure
so that it is flat.
2) Position the pilot figure on the canopy floor
as show. Locate the oval shaped on the canopy
floor and remove the covering. Use epoxy to
glue this into the base of the pilot figure, please
see pictures as shown.
Instruction Manual.
Nylon Clevis
Fuel Tubing
Pushrod Elevator
Fuel Tubing
Nylon Clevis
INSTALLATION PILOT.
1
2