Power Saving Mode (Mode 6); Sleep Mode (Mode 7); Instruction Format - Ebyte E70-915T14S User Manuel

Chengdu Ebyte Electronic Technology Co,;Ltd
Parameter configuration can be made in configuration mode with specific instruction format and UART 9600,
Configuration
8N1.
When entering other modes from configuration mode, the module will reconfigure parameters, AUX keeps low
Note level during configuration;
After configuration completed, it outputs high level, so users are recommended to check the AUX rising edge.

6.8 Power Saving Mode (Mode 6)

Status M0=0 M1=1 M2=1
Transmitting Transmission is not available.
Receiving Receiving is available.
Baud rate & air Under this mode, the baud rate and air data rate are independent, both receiver and transmitter can have different
data rate baud rate but same air data rate.
The module works under WOR status, it wakes up periodically and monitors the wireless data packets, when data
Advantage packet monitored, the module enters receiving mode and receives complete data packets, and outputs the data
through serial port, and then enters WOR status again, which can save power consumption significantly.
Disadvantage Transmission is not available under this mode, the module must be switched to other mode for data transmission.
Applications Applicable for those devices which have requirement on power consumption and need to receive data.
Note It can only receive the data sent from the transmitter under mode 4.

6.9 Sleep Mode (Mode 7)

Status M0=1 M1=1 M2=1
Transmitting Transmitting is not available.
Receiving Receiving is not available.
Others Other functions of the module are closed, only can quit sleep mode by switching the M 0, M 1 and M 2 status.

7.Instruction Format

In configuration mode（Mode 3：M0=1, M1=1, M2=0）, it supports instructions below.
(Only support 9600 and 8N1 format when setting)
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co,;Ltd
E70-915T14S user manual
15