Use
Emergency Alert Message Generation
Pressing and holding the pendant button for more than 3 seconds
until both LEDs blink green and orange will trigger an emergency
alert notification message. The LEDS will continue to blink until
the emergency alert is acknowledged. Upon panic, the gateway
interface box will open the 'normally closed connection" for
one second allowing data communication equipment device to
generate Emergency Alert Message.
Note: The button can be pressed at any time, even when the
pendant is powered down. If the button is pressed, the pendant
will power up and transmit the alert notification message. When
the button is pressed while pendent is powered down, button
needs to pressed for more than 6 seconds, to generate panic.
Function
Send EMERGENCY alert
Confirmation of Emergency Alert
If the alert message is successfully delivered to the remote
monitoring station a successful acknowledgement will be sent to
the pendant indicating help is on the way. If the message fails to
reach the monitoring station the pendant will continue to retry
indefinitely. If the pendant receives a unsuccessful acknowledgment
message, the user is notified via a unsuccessful acknowledgement
sound sequence. Upon receiving a successful acknowledgement the
pendant will beep twice in an escalating tone and vibrate 4 times. If
the message is unsuccessful acknowledged, the pendant will play a
high-low sound sequence twice.
Man Down Kit - F5 Installation & User Manual
Send EMERGENCY Alert
Press and hold (for > 3
seconds) until both LEDs
blink green and orange.
Description
Press and hold for > 3
seconds until both LEDs
blink green and orange.
15