Bose Wave PC system Owner's Manual page 8

System Setup
Figure 2
Locating the slot-type
safety lock
Figure 3
Locating the tab-type safety
lock
8
Setting up the Wave/PC
WARNING: Keep the remote control battery away from children. It may cause a fire or chem-
ical burn if mishandled. Do not recharge, disassemble, heat above 100˚C (212˚F), or inciner-
ate. Dispose of used battery promptly.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
Note: Some remote control functions will not work until your Wave/PC unit is connected to
your computer and the Wave/PC software is installed.
Your remote control may be one of two types. Each is identified by the way the battery com-
partment unlocks to install or replace the battery (Figure 2 or Figure 3).
1. Place the remote control face down on a flat surface.
2. If your remote has a slot on the back (Figure 2), follow step A. Otherwise, follow step B
and refer to Figure 3:
A. Insert the tip of a ballpoint pen into the slot. Push to the side (as shown) and hold.
Slide the battery compartment open with your finger.
B. Using your finger, push the tab lock to the side (as shown) and hold. Slide the battery
compartment open.
Slot
Note: Use only a Duracell, Eveready, Maxell, or Toshiba CR2032 or DL2032 lithium battery
(available at electronics stores). If you have difficulty finding a replacement battery, contact
Bose ® Customer Service. (See phone numbers on the inside back cover.)
3. Keeping the remote control face down, insert the new battery into the compartment with
the + symbol facing up.
4. Gently slide the battery compartment closed. It locks automatically.
April 12, 2001
™ remote control
Tab
+ Symbol
+ Symbol
PDF259774_00