Bose Wave PC system Owner's Manual page 10

System Setup
Figure 6
Example 1: Wave/PC sys-
tem connections
10
Connecting the Wave/PC
This step tells you how to connect the Wave/PC unit to your computer using the cable sup-
plied with your Wave/PC system. Illustrations of the two most typical computer connection
panels are provided (Figure 6 and Figure 7). Refer to the figure that best represents your com-
puter and the following steps.
Note: If you are using stereo speakers with your computer, disconnect them before continu-
ing with this procedure.
1. Turn your computer off.
2. Insert the DIN connector of the Wave/PC system cable into the DIN socket on the rear
panel of the Wave/PC unit (Figure 6 or Figure 7).
3. Connect the serial data port (DB-9) connector of the Wave/PC system cable to the serial
(RS232) data port of your computer (Figure 6 or Figure 7).
4. Connect the audio plug (3.5 mm) of the Wave/PC system cable to the audio output jack
of your computer (Figure 6 or Figure 7).
CAUTION: Do not connect the Wave/PC unit to an AC (mains) outlet until after connecting
your Wave/PC unit to your PC.
Serial data
port
Serial data
port (DB9)
connector
Audio plug
April 12, 2001
™
unit to your computer
Rear panel of computer
Audio
output
jack
DIN socket
DIN connector
Wave/PC system cable
PDF259774_00