CreamWare Noah Vocodizer Manual page 8

Input
Here you control the levels of the analysis
and synthesis inputs, and include effects
if desired.
Analysis Input
InGain: Adjusts the level of the analysis
input signal with up to 24dB of
amplification. Use the level meters to help
set a satisfactory level.
Pay close attention to your levels. In
particular, avoid letting signals
overload the input. It's not so much that
strong signals create audible problems
with distortion; the bigger problem is
that they influence the automatic
controls to produce unexpected
results.
Note that changes to the input gain
have an influence on the voiced/
unvoiced detection process. Usually
you will also have to adjust the
Threshold setting after you change the
gain control setting.
Vocodizer
Synthesis Input
Here you ajust the level of the synthesis
input signal with amplification of up to
24dB. Use the level meters to help set
the correct level.
Again, pay close attention to the level,
especially avoiding signals that are too
strong. Such signals will produce
unexpected high
components in the synthesis signal.
Solo: Click one of these buttons to hear
only the analysis or synthesis input signal.
Attention: Often the input signal level
is higher than the Vocodizer's output
level. In this case, turn down the Ma-
ster Volume control.
frequency
Contents
8
Index