Related Manuals for Bose 701 Series II
Summary of Contents for Bose 701 Series II
- Page 1 The Bose 701 Direct/Reflecting ® ® Series II Speakers Owner’s Guide October 25, 2001 AM257817_00_V.pdf...
-
Page 2: Important Safety Information
701 speakers properly. Save your owner’s guide for future reference. ©2001 Bose Corporation. No part of this work may be reproduced, modified, distributed, or otherwise used without prior written permission. All trademarks referenced herein are the property of Bose Corpo- ration. -
Page 3: Table Of Contents
1-year warranty. Details of the coverage are provided on the warranty card that came with your speakers. Please fill out the information section on your card, detach, and mail to Bose. For your records The serial number is located on the label on the back of each speaker. -
Page 4: Setting Up
Setting Up Introduction Your 701 sound energy for a lifelike, spacious performance. As with all Bose meant to bring you high-quality concert-like sound. Figure 1 A natural balance of direct and reflected sound. Unpacking the speakers Carefully unpack the contents of the shipping carton. -
Page 5: Placing The Speakers
10 inches (25 cm) from the wall behind it. Figure 3 Ideal speaker placement Note: Bose tables. They are designed as floor-standing speakers only. WARNING: To prevent personal injury, do not place your speakers in high-traffic areas where they can be accidentally knocked over. -
Page 6: Choosing The Speaker Cord
Note: If you require longer cable runs, or have speaker wire already installed in the wall, the Bose AC-7 adapter kit is available to accommodate this. The kit will also allow for the use of a larger gauge speaker wire. Refer to the enclosed list for correct phone numbers to order PN262061. -
Page 7: Connecting The Right Accessory Speaker To The Left Main Speaker
They are labeled with an R. Connecting the right accessory speaker to the left main speaker Use the supplied Bose connector at each end is designed to be inserted in one orientation only. Match the curved top of the connector to the curved top of the jack on the rear connector cups. -
Page 8: Connecting The Lfe Subwoofer Input
Setting Up Connecting the LFE subwoofer input If your receiver or amplifier has a Subwoofer or Low Frequency Effects (LFE) channel output, use a single RCA male to RCA male patch cord to make the connection. Connect the “LFE/ Subwoofer” input on the left main speaker to the LFE/subwoofer output of your receiver or amplifier (Figure 7). -
Page 9: Setting Your Non-Digital Receiver
Setting your non-digital receiver After making the connections, you may try additional surround sound modes that your receiver may have. These modes may have different names depending on the manufacturer, e.g. ACTION, MOVIE, THEATER. Select the settings for music, movies, or both that sound best in your listening environment. -
Page 10: Reference Information
2. Check your amplifier or receiver owner’s guide, since other components may be the cause of the problem. 3. Use the chart below as troubleshooting guidelines. If this does not solve the problem, contact your authorized Bose correct phone numbers. Problem One speaker doesn’t play or... -
Page 11: Technical Information
12 (3.3 mm Customer service For additional help in solving problems, contact Bose list of Bose customer service offices and phone numbers. Cleaning Wipe the 701 allow liquids to spill on or objects to drop into the speaker grilles. You may vacuum the grilles carefully;... - Page 12 ©2001 Bose Corporation, The Mountain, Framingham, MA 01701-9168 USA 257817 AM Rev.00 JN10651...