Changing The House Code Settings - Bose Lifestyle 30 Series II Owner's Manual

Maintaining Your Lifestyle

Changing the house code settings

Figure 30
Miniature switches for setting
house codes and zones
Figure 31
Display confirming an example
of house code setting: switch 1
up, switches 2, 3, and 4 down
32
®
30 System
®
Each Lifestyle remote control uses a system of matching house codes to communicate with
its corresponding music center. If your remote's commands ever conflict with those of
®
another nearby Lifestyle system, you can easily set a new house code for your system and
its remote control(s) by following the procedures below.
1. Open the remote control battery cover and locate the miniature switches (Figure 30).
2. To create a new code, change the position of switches 1, 2, 3, or 4 by moving them in the
opposite direction from their current settings. Use a paper clip, ball point pen, or similar
object.
Note: Do not change switches 5, 6, or 7 at this time. The manufacturer's standard setting is
switch 5 up and switches 6 and 7 down.
3. Replace the battery cover.
4. Lift the music center door.
5. Turn both zones off.
6. Press and hold the STORE key. The display will begin to flash PROGRAM.
7. While you hold the STORE key and the display is flashing, press any key on the remote
control.
• The display stops flashing and momentarily shows PROGRAM to confirm recognition
of a new house code.
• The display verifies the house code by lighting four rectangles corresponding to the
four switch positions (up or down). See the example in Figure 31.
8. Release the STORE key. The system remains off.
9. If you have additional remote controls, change the switches to match those of the first
remote control. It is not necessary to repeat steps 4-8.
Note: To verify your system's house code, press STORE while the system is off. The display
confirms the settings of switches 1-4.
October 29, 2001
House code switches
K
ON 40
l 2 3 4 5 6 7 8
AM199736_06_V.pdf