Particularity With The Option Handicapped Equipment; Equipment; Assembling And Disassembling - iKarus C42 Series Pilot Operating Handbook

Pilot Operating Handbook for the C42 Series
17.
Handicapped Equipment
17.1
If the following additional equipment is installed in the aircraft, it can be
operated without using the feet to control the nose wheel and the rudder:
a.) modified throttle shaft including throttle lever extension
b.) rudder control lever with push rod
c.) placard on the rudder control lever.
Installation must be undertaken in accordance with the instructions of the
manufacturer. The unauthorised alteration of the equipment for
handicapped pilots is not permitted.
17.2
The rudder control lever is installed by attaching to the mounted axle in
the main tube and bolting with a hexagonal bolt M8xM40.
The push rod which is attached to the rudder control lever is connected to
the right pedal of the left seat by a quick-release fastener. The sliding
sleeve of the quick-release fastener is then checked for a proper fit in the
locked position.
Throttle lever length is then set so that the knob of the throttle lever is
approximately ten to thirty millimetres under the rudder control lever and
can pass freely under it.
The additional control equipment is disassembled in reversed order
POH C42 SERIES ISSUE1 (B) REV7
Particularity with the Option

Equipment

Assembling and Disassembling

25/04/2020 Page 58 of 73