iKarus C42 Series Pilot Operating Handbook page 47

Pilot Operating Handbook for the C42 Series
Step 6
1.
2.
3.
4.
5.
Repeat the step 1 to 6 fo the other wing.
Remove any aileron locks used.
Step 7
Step 8
Step 9
Step 10
POH C42 SERIES ISSUE1 (B) REV7
Attention and now immediately
Insert mounting bolts into the front wing spar bracket
Insert mounting bolts into the rear wing spar bracket
Insert toggle bolt into the square cross-frame spar to
secure the wing support.
All three bolts must be secured with the ring pins!
Lift the wing to check that the wing support is fixed tight
by the toggle bolt!
Attach right and left aileron push rods to the see-saw
connection. Carefully assure that the slide mechanism of
the special ball-joint connectors is in completely closed
position.
Left and right flaps connection must be locked.
Connect the pitot tube in his connector and if installed,
connect the beacons.
Fasten wing center section fairing.
25/04/2020 Page 47 of 73