Commissioning; Installation - Conrad Mc Crypt LumiZIP1 Instruction Manual

7. Commissioning

To ensure that the device is set up correctly, always read these operating instructions including
the safety instructions thoroughly and attentively before use.
Check the device for damage before using it. If the device is damaged, do not operate it and
consult an expert or our service team.

7.1 Installation

Assembly and installation of the device must be carried out by a specialist familiar with the
hazards and the relevant regulations. Maintenance, operation and commissioning of this
device must only be carried out by qualified persons.
When choosing a location for your device, make sure to avoid impact, vibration, dust, hot and
cold temperatures and dampness. There also must not be any powerful transformers, motors
or other devices with a strong interference emission in the device's proximity.
Never cover the device. Make sure when mounting with other equipment that there is sufficient
ventilation. Maintain a distance of at least 15 cm to other devices and walls. Never install the
effect light in direct proximity of heat sources. Do not point any strong spotlights or light
sources towards the device. This may cause overheating (danger of fire!).
The effect light must only be operated at a maximum ambient temperature of 35°C and a relative
humidity of max. 75%.
Do not drill or screw additional screws in the housing in order to fasten the device. This may
expose dangerous voltage to touch.
The device must be mounted out of normal reach.
Easily flammable materials like decorative fabrics must have a distance of at least 0.5 m to the
device. Otherwise, such objects may catch fire!
When mounting the product, make sure that the power cord is neither jammed nor damaged by
sharp edges.
During installation or service work, the area below the place of installation must be cordoned
off. Never stand below the place of installation either.
The installation surface or mounting fixture needs to be designed in a way that it can take 10
times its load capacity for at least 1 hour without permanent damaging deformation.
It is also essential that the device is secured by means of a second safety restraint that is
independent of the actual mounting supports when installing it in an elevated position. No part
of the installation must fall down if the main suspension system fails.
Observe all relevant regulations of your country when installing the device.
24