Advertisement
5
Base A
• Place base A and base B (there is an A or B on the under-
side of each base) on a flat surface, peg side up.
• Turn the threshold upside down and fit it onto each peg,
as shown.
• Insert two
1
/
" screws through the threshold and into each
2
base. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
6
Column B
Assembly
Slots
Tabs
Base B
Push Up
• Turn the threshold assembly upright.
• Align column A assembly to base A and column B assembly
to base B.
• Fit the tabs on the bases into the slots in the columns.
• Push the threshold up to lock it in place.
Threshold
Pegs
Column A
Assembly
Slots
Tabs
Base A
Threshold
Push Up
7
Base B
Knobbed
Post
Counter
Top A
• Turn the assembly upright, as shown.
• Position the knobbed post so that the collar end is downward.
• Fit the knobbed post into the hole in counter top A.
• Position the post so that the collar end is downward.
• Fit the post into the hole in counter top B.
8
Arch A
• Position arch A and arch B upside down on a flat surface.
• Fit the center arch onto arch A and arch B. Make sure all
three arch pieces form a "U-shaped" archway.
• Insert two
arch A and arch B. Tighten the screws with a Phillips screw-
driver. Do not over-tighten.
IMPORTANT! DO NOT insert screws through the lower holes
in the center arch.
4
Collar End
Collar End
Hole
IMPORTANT! DO NOT insert
screws into lower holes.
Upper Holes
Center Arch
1
/
" screws through the upper, center arch and into
2
Post
Hole
Counter
Top B
Arch B
Advertisement
