Added New Drying Operation; Reducing Media Consumption Between Job To Job - Ricoh Pro L5130 Manual

Added New Drying Operation

Added New Drying Operation

Reducing Media Consumption Between Job to Job

[Overview]
Added the new drying operation to reduce media consumption between jobs.
This function described in this chapter is available from the following firmware versions.
System : 2.03 or later
Engine : 2.03:01 or later
[How to operate]
⚫
Prevent Drying After Printing
When "Prevent Drying After Printing" is set to "On" by following the steps below, the
machine does not dry the printed image after printing. So, it can reduce the amount of
media used, because the margins that are required for drying are reduced.
The undried part at the end of the printed image dries when you print the next job.
1. Press [Standard Procedure] key.
2. Press [Dry After Printing].
3. Press [Prevent Drying After Printing]
[ON]: Do not dry the printed image after printing
[OFF]: Dry the printed image after printing (Default)
Note:
-
If you use this feature and print the next image with a different print mode, drying
may not be enough. Therefore, it is recommended to print the next jobs in the same
print mode or in a print mode with a large number of passes. If you print with a
different print mode, print quality cannot be guaranteed.
-
The printed image is left on the post-heater, which may cause waving of the media
or melting the release paper (for adhesive media).
-
This function will not operate if you have specified the settings for "Auto Cutting
Media after Printing"
(*1): Also called "Roll to Cut", it can be work by changing the RIP settings. For
details, please refer to the separate "Solutions manual".
(*2): It can be work by [Standard Procedure] key -> [Media Settings] -> [Auto
Rewinding after Drying]. For details, please refer to the separate "Solutions
manual".
(*1)
or if "Auto Rewind after Drying"
10
(*2)
is set to "On".